fantasticiorew.blogg.se

1. #Construction master pro desktop percision install
2. #Construction master pro desktop percision drivers
3. #Construction master pro desktop percision code
4. #Construction master pro desktop percision plus

#Construction master pro desktop percision drivers

The easy setup process includes the free download of 1-Wire drivers and the OneWireViewer demonstration software to easily communicate with iButton devices through the PC's USB port. All other iButton devices may be purchased separately. Please note that the DS1921 is the only iButton device included in the kit. The DS1921K is also capable of evaluating any other iButton devices, including the high-capacity Thermochron devices (DS1922L, DS1922T, and DS1923), the Hygrochron ™ device (DS1923), and the temperature-only iButton device (DS1920). The kit includes a DS1921 Thermochron iButton device and all hardware required to communicate with it. The kit uses the USB port of a Microsoft Windows ®-based Personal Computer running Vista ®, XP SP2 (or higher), or Microsoft Server Operating Systems Windows 2003 or 2008. The DS1921K Thermochron ™ iButton ® Starter Kit provides the basic hardware for a quick evaluation of Maxim’s Thermochron iButton family that communicates using the 1-Wire ® protocol. Supported by Atmel Studio and QTouch Composer TFT-LCD Display Interface Connector: RGB, 18-bitsġ standard SD card with 3.3v/1.8v power switchĮthernet Interface: 1 10/100 Ethernet PHYĤ Push Button Switches (Disable Boot, Reset, Wake Up, User Configurable)ġ set of XPRO wing connectors (QTouch extension boards interface)Īuto-ID for board identification in Atmel Studio

#Construction master pro desktop percision code

Simply connect any DM320001, DM320003-2, DM320004, DM330012 and DM240012 Starter Kit to the MEB and you're ready to develop, program and debug code for the user interface features. The board comes with a 3.2 color TFT touch-screen QVGA display, an onboard FCC-certified W-iFi ® module, a 24-bit stereo audio code, a three-axis accelerometer, a joystick and a microSD®®™ memory card slot. The Multimedia Expansion Board (MEB) provides PIC32 Starter Kit, dsPIC33E USB Starter Kit or PIC24E USB Starter Kit users with an integrated-yet flexible-solution for the development of high-impact user interfaces. Afterward, the features can be enabled or disabled easily by installing or removing the jumper.

#Construction master pro desktop percision install

To change this, the user will need to cut the traces and install pins and a block jumper. As shipped from the factory, some of the jumper locations are bridged by circuit traces forming a default setup. When connecting to the two boards together, pay close attention to the orientation of the connector and pin alignment.Ī total of 7 jumper locations are available. Most PICDEM demonstration board do not have the female header installed, so if using a PICDEM board, a 14x2 female connector is included with this kit for the user to install onto the development board if necessary.

#Construction master pro desktop percision plus

In general, a board is compatible if it has a PICtail™ or PICtail™ Plus interface expansion port. To get started, a compatible MCU development board is required.

Microchip Technology’s firmware(AN1003) is only implemented on PICDEM™ FS USB. A complete list of compatible PICDEM™ borad is available on Microchip’s website. It is an expansion board compatible with a number of development tools for 8/16/32bit MCU’s and DSC’s. The PICtailTM Daughter Board For SD™ and MMC cards is a demonstration board for evaluating reading and writing data on SD or MMC cards.